Configuring Timeouts - Dell S3048-ON Configuration Manual

dot1x reauthentication [interval] seconds
The range is from 1 to 31536000.
The default is 3600.
• Configure the maximum number of times the supplicant can be re-authenticated.
INTERFACE mode
dot1x reauth-max number
The range is from 1 to 10.
The default is 2.
Example of Re-Authenticating a Port and Verifying the Configuration
The bold lines show that re-authentication is enabled and the new maximum and re-authentication time period.
Dell(conf-if-gi-1/1)#dot1x reauthentication interval 7200
Dell(conf-if-gi-1/1)#dot1x reauth-max 10
Dell(conf-if-gi-1/1)#do show dot1x interface GigabitEthernet 1/1
802.1x information on Gi 1/1:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Auth Type:
Auth PAE State:
Backend State:
Auth PAE State:
Backend State:

Configuring Timeouts

If the supplicant or the authentication server is unresponsive, the authenticator terminates the authentication process after 30 seconds by
default. You can configure the amount of time the authenticator waits for a response.
To terminate the authentication process, use the following commands:
• Terminate the authentication process due to an unresponsive supplicant.
INTERFACE mode
dot1x supplicant-timeout seconds
The range is from 1 to 300.
The default is 30.
• Terminate the authentication process due to an unresponsive authentication server.
INTERFACE mode
dot1x server-timeout seconds
The range is from 1 to 300.
96 802.1X
Enable
FORCE_AUTHORIZED
UNAUTHORIZED
Enable
None
90 seconds
120 seconds
10
30 seconds
30 seconds
7200 seconds
10
SINGLE_HOST
Initialize
Initialize
Initialize
Initialize