NETGEAR S3300 User Manual page 46


To display the USB Device Information page:
1. Select System > Management > USB Device Information.
2. The USB Device Information screen displays as shown in
Information.
3. Click Update to update the information on the page to the latest data on the switch.
Note: The system only detects and manages the USB device installed in the
master unit.
The limitations for the USB Device supported on the S3300 are as follows:
• The USB disk should comply for USB 2.0.
• The USB disk should have a filetype of FAT32 or VFAT. NTFS is not supported.
• The write/read speed is about 1 Mbps due to a hardware limitation.
Figure 27. USB Device Information
Table 11 describes the nonconfigurable information that the USB Device Information screen
displays.
Table 11. USB Device Information
Field
USB Device Details
Device Status
USB Memory Statistics
Total Size
S3300 Smart Managed Pro Switch
Description
Specifies the current status of device.
• Active if the device is USB plugged in and recognized by the switch.
• Inactive if the device is not mounted.
• Invalid if the device is not present or an invalid device is plugged in.
Displays the USB flash device storage size in bytes.
Configure System Information
46
Figure 27, USB Device