Configure The Network Settings On The Administrative System - NETGEAR S3300 User Manual

Figure 3. Smart Control Center - Configure Device
9. Type your password to continue with the configuration change.
Tip: You must enter the current password every time you use the Smart
Control Center to update the switch setting. The default password is
password.
Click the Apply button to configure the switch with the network settings.
10.
Ensure that your computer and the switch are in the same subnet. Make a note of these
settings for later use.
Configure the Network Settings on the Administrative
System
If you choose not to use the Smart Control Center to configure the network information on the
switch, you can connect directly to the switch from an administrative system, such as a
computer or laptop. The IP address of the administrative system must be in the same subnet
as the default IP address on the switch. For most networks, this means you must change the
IP address of the administrative system to be on the same subnet as the default IP address
of the switch (192.168.0.239).
S3300 Smart Managed Pro Switch
Getting Started
17