NETGEAR S3300 User Manual page 181

2. Select each interface to configure.
For information about how to select and configure one or more ports or LAGs, see
Configuring Interface Settings
3. Use the Multicast Router field to enable or disable Multicast Router on the selected
interface.
4. Click the Apply button.
Multicast Router VLAN Configuration
The statically configured router attached (VLAN, Interface) is added to the learned multicast
router attached interface list if the interface is active and is a member of the VLAN. Unlike in
the previous release of the system firmware, snooping dynamic learning mode (snooping
interface mode or snooping VLAN mode) does not need not be enabled on the interface. The
dynamic learning mode is applicable only for dynamically learnt multicast router information
(Queries from an attached true Querier).

To configure the multicast router VLAN:
1. Select Switching> Multicast > MLD Snooping > Multicast Router Configuration VLAN
Configuration.
2. From the Interface menu, select the interface to configure.
3. In the VLAN ID field, specify the VLAN ID for which the multicast router mode is to be
enabled or disabled.
4. From the Multicast Router field, select Enable to enable the multicast router on the selected
interface, or select Disable to disable the multicast router on the interface.
5. Click the Apply button.
Querier Configuration
Use this screen to enable or disable the MLD Querier Configuration feature, specify the IP
address of the router to perform the querying, and configure the related parameters.

To configure the querier settings:
1. Select Switching> Multicast > MLD Snooping > Querier Configuration.
2. Next to the Querier Admin Mode field, enable or disable the administrative mode for MLD
snooping querier.
3. In the Querier Address field, specify the snooping querier address to be used as source
address in periodic MLD queries.
This address is used when no address is configured on the VLAN on which query is being
sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x.
4. In the MLD Version field, the MLD protocol version used in periodic MLD queries is
displayed.
The supported MLD Version is 1.
S3300 Smart Managed Pro Switch
on page 32.
Configuring Switching
181