Processor - HP ProLiant DL160 Gen9 Maintenance And Service Manual

Finish the installation by completely tightening the screws in the same sequence.
c.
Install the access panel.
4.
Do one of the following:
5.
Slide the server into the rack.
o
Install the server into the rack.
o
Connect each power cord to the server.
6.
Connect each power cord to the power source.
7.
Press the Power On/Standby button.
8.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.

Processor

The server supports single-processor and dual-processor operations.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
CAUTION: To prevent possible server overheating, always populate processor socket 2 with
a processor and a heatsink or a processor socket cover and a heatsink blank.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
Removal and replacement procedures 52