Non-Hot-Plug Drive - HP ProLiant DL160 Gen9 Maintenance And Service Manual

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
3.
Remove the drive carrier.
4.
To replace the component, slide the component into the bay until it clicks.

Non-hot-plug drive

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 27).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
4.
Remove the non-hot-plug drive.
5.
("Remove the security bezel
("Remove the security bezel
Removal and replacement procedures 32
(optional)" on page 26).
(optional)" on page 26).