Menu Trees For 'El' Operation Mode - Siemens FDUL221 Technical Manual

6.1.1
Building Technologies
Fire Safety

Menu trees for 'EL' operation mode

1. To navigate in the 'Topology' menu tree, switch the FDUL221 line tester on.
2. To navigate in the 'Configuration' menu tree, press the
the FDUL221 line tester on at the same time.
The software version is briefly shown on the display.
3. Use the buttons to navigate.
'Configuration' menu tree
1. To navigate in the 'Configuration' menu tree, press the
the FDUL221 line tester on at the same time.
The display shows 'LineTester Config'.
2. Use the buttons to navigate.
3. Exit the 'Configuration' menu tree via 'Save & Exit' or 'Exit'.
'Topology' menu tree
The detector line is connected [
1. Switch on the FDUL221 line tester.
The software version is briefly shown on the display.
2. Use the buttons to navigate.
3. Select the following to read in the line topology:
- For a loop or a sub-stub on a loop, select 'Startup Loop A->B'.
- For a stub or a single line device, select 'Startup Stub A'.
4. Exit the 'Topology' menu tree by switching the FDUL221 line tester off.
Navigating in the menu tree
47].
Operation 6
button and switch
button and switch
43
008250_i_en_--
2013-08-15