Siemens FDUL221 Technical Manual page 70

7 Maintenance / Repair
Firmware update
70
Building Technologies
Fire Safety
Firmware update by PC
Permanent and safe power supply to the FDUL221 line tester is available while
the update is taking place.
The file required for the firmware update is available. You will find the file on
the CD included in the set or on the Intranet in the Customer Support Center
1. Load the firmware update on the PC.
2. Connect the FDUL221 line tester to the PC.
3. Connect the FDUL221 line tester to the mains and switch it on.
4. On the PC, open the directory in which the firmware is located.
5. Select the required firmware version.
6. Start the download by double-clicking on the file *.exe'.
7. Follow the instructions indicated on the PC screen.
8. In the case of initial installation, select the available connection variant.
9. Follow the prompt to press the
10. Hold the buttons down and follow the instructions.
The update has been successfully installed.
11. Disconnect the FDUL221 line tester from the PC.
12. Configure the FDUL221 line tester and save the configuration. [
13. Switch off the FDUL221 line tester.
The update is complete.
obtain from: Customer Support Center/PSP Product Support Platform CSC
1)
address: https://intranet.sbt.siemens.com/fs/CSC/
Firmware update with FS20/Cerberus PRO FS720 fire detection
system
In the Sinteso FS20/Cerberus PRO FS720 fire detection system, the firmware
update can also be performed with the FXS2007 engineering tool or with the
FXS2008 periphery update tool.
You will find detailed information about firmware updates for the FS20 fire detection
system in document 009052 and for the FS720 fire detection system in document
A6V10210416.
See also
Operating the line tester with a PC [
Applicable documents [
buttons on the FDUL221 line tester.
50]
56]
7]
.
1
008250_i_en_--
2013-08-15