El' Operation Mode; Functions In The 'Topology' Menu - Siemens FDUL221 Technical Manual

5 Structure and function
Function
5.4.3
5.4.4
38
Building Technologies
Fire Safety

'EL' operation mode

The FDUL221 line tester can be used in 'EL' operation mode. The 'EL' operation
mode is only intended for use by electricians.
In 'EL' operation mode, the detector lines can be read in, checked and saved.
Changing the operation mode
To change the operation mode, a firmware update must be carried out on the
FDUL221 line tester. The firmware for the 'EL' operation mode is marked with the
suffix 'electrician'. You will find more information in chapter 'Firmware update
69]'.

Functions in the 'Topology' menu

The following menus and functions
1
Testing the line topology
Reading in the line
Line devices
– Recognizing the line devices
– Address
– Series number
– Device type
– Checking the device status
– Error list
– Status
– Activating the sounds of audio devices (not in 'EL' operation mode)
– Alarm indicators
– Line separation function (not in 'EL' operation mode)
– Relay in input/output module (not in 'EL' operation mode)
Manage Memory (only in 'EL' operation mode)
Error
Monitoring
– Open line
– Ground fault
– Short-circuit
– Missing line devices
– New line devices
Config. sounder base (not in 'EL' operation mode)
Type Overview
Reset addresses
Depending on the operation mode, not all menus and functions are available.
1
See also
Navigating in the menu tree [
are available in the 'Topology' menu tree:
1
40]
008250_i_en_--
2013-08-15