Splitting The Last Cut Piece Of Wood; Splitting A Split Piece Of Wood; Removing Wood Caught In The Splitting Blade - Hakki Pilke OH 27 Instructions For Assembly, Operation And Maintenance

Splitting the Last Cut Piece of Wood

1. Bring the
control lever to the Stop
position.
4. Close the splitting chute cover and bring the splitting control lever to the In
operation position.
5. Start the splitting with the pedal.
Do as instructed above in section Splitting the Last Cut Piece of
Wood (page 22).

Removing Wood Caught in the Splitting Blade

If the splitting cylinder does not have the power to split the wood intended for
splitting, do as follows:
1. Bring the splitting control lever to the Reverse position to return the splitting
cylinder to its initial position.
2. Leave the control lever in the Stop position.
3. Open the splitting chute cover using the handles.
Look out for the splitting blade during the removal!
4. After removing the wood, move it to the side or put it back into the splitting chute
and lower the splitting blade to its lowest position. The blade will then split the wood
only into two pieces, for which the cylinder has enough power.
5. Lower the splitting chute cover and move the splitting control lever to the In
operation position.
6. Start the splitting movement with the splitting pedal.
Hakki Pilke 27
splitting 2. Open the splitting
chute cover using the
handles.
Cover lifting
handles

Splitting a Split Piece of Wood

24 (39)
Original
3. Drop the wood into
the splitting chute.
Version 5-2014