QNAP TS-110 Software User Manual page 251

steps:
1. Click "Get Started" to use the wizard.
2. Click "Start".
3. Fill out your myQNAPcloud ID(QID) and password. Click "Next" (or click "Create
myQNAPcloud account" to sign up a myQNAPcloud account if you don't already have
an account.)
4. Enter a name to register your NAS and click "Next".
5. Select to enable the myQNAPcloud services (Auto Router Configuration, DDNS,
Publish Services and CloudLink) and set the level of access control. Click "Next".
6. The wizard will configure your router automatically.
7. Review the summary page and click "Finish" to complete the wizard.
Auto Route r C onfigura tion
In "Auto Router Configuration", you can enable/disable UPnP port forwarding. When
enabled, your NAS is accessible from the Internet via the UPnP router.
Note: If there is more than one router on the network, only the one which is set as
the default gateway of the NAS will be detected.
If no UPnP router is found on the local network, click "Rescan" and "Diagnostics" to
check the diagnostic logs. If the UPnP router is incompatible with the NAS, click the
tooltip icon (!) and then click "UPnP Router Compatibility Feedback..." (http://www.
qnap.com/go/compatibility_router.html) to contact technical support. Select the NAS
services to be allowed for remote access and click "Apply to Router". The NAS will
automatically configure the port forwarding on the UPnP router. You will then be able to
access NAS services from the Internet.
Note :
If more than two NAS are connected to one UPnP router, please specify a
different port for each NAS. If the router does not support UPnP, users must
manually configure port forwarding on the router. Please refer to these links:
Application notes: http://www.qnap.com/go/notes.html
FAQ: http://www.qnap.com/faq
UPnP router compatibility list: http://www.qnap.com/
UPnP_Router_Compatibility_List
251