Comparison Of International Standards - Raytech TR-MARK III Instruction Manual

4.2.2 Comparison of International Standards

High Winding Side:
Wire Color ANSI
RED H1
BLACK H2
BLUE H3
YELLOW H0
Low Winding Side:
Wire Color ANSI
RED X1
BLACK X2
BLUE X3
YELLOW X0
NOTE
⇒ This manual refers to the ANSI standards for all examples. To change
WARNING!
⇒ BEFORE OPERATING THIS OR ANY OTHER TEST EQUIPMENT
⇒ DO NOT VARY INPUT VOLTAGE (MAINS) AFTER POWERING ON
⇒ The TR-MARK III auto-senses the input (mains) voltage from 100 TO
⇒ The TR-MARK III then "locks–in" the test voltage range. If the input
90100.1.02 Instruction Manual TR-MARK III
Wire Color
RED
BLACK
BLUE
YELLOW
Wire Color
RED
BLACK
BLUE
YELLOW
the standard in the test instrument please refer to chapter '8.5.3
Standards'.
READ ALL SAFETY WARNINGS AND UNDERSTAND THEM FULLY.
TEST SET.
240 VAC 50 / 60 Hz.
voltage (mains) is varied after the TR-MARK III was powered on the
actual test voltage may be higher or lower than indicated and system
may get damaged
IEC Wire Color
U RED
V YELLOW
W BLUE
N BLACK
IEC Wire Color
u RED
v YELLOW
w BLUE
n BLACK
Australian
A
B
C
N
Australian
a
b
c
n
Page 14 of 70