Rxgoose Statistics; Channel Tests - GE L30 Instruction Manual

STATUS
The L30 is provided with optional IEC 61850 capability. This feature is specified as a software option at the time
of ordering. See the Order Codes section of chapter 2 for details.
The
All RxGOOSE Online
Input.

6.3.9 RxGOOSE statistics

ACTUAL VALUES  STATUS  RxGOOSE STATISTICS  RxGOOSE 1(64)
 RxGOOSE 1

The L30 is provided with optional IEC 61850 capability. This feature is specified as a software option at the time
of ordering. See the Order Codes section of chapter 2 for details.
— State number. The most recently received value in GOOSE message field stNum. The publisher increments stNum
stNum
each time that the state of one or more of the GOOSE message members is sent with a revised value.
— Sequence number. The most recently received value in GOOSE message field sqNum. The publisher sets sqNum
sqNum
to zero each time the state of one or more of the GOOSE message members is sent with a new value, and it increments it
whenever a GOOSE message is resent without any member value change.
— Multicast (SSM and ASM) modes of R-GOOSE reception require that the L30 device subscribe to a multicast group
IGMP
over the Internet Group Management Protocol (IGMP) enabled network. R-RxGOOSE## IGMP status On indicates that IGMP
6
negotiation with a network device (for example a router) was successful. In the case where setting R-RxGOOSE1 DST IP is
configured to a multicast address and this status indicates Off, R-GOOSE reception cannot be successful, and therefore
communication network diagnosis needs to be carried out. This status is relevant to R-GOOSE reception when configured
for SSM or ASM reception modes. It is not relevant for GOOSE or for R-GOOSE in unicast reception mode.

6.3.10 Channel tests

ACTUAL VALUES  STATUS  CHANNEL TESTS
 CHANNEL TESTS

6-6
actual value does not consider RxGOOSE that are not configured or are not used by any RxGOOSE
RxGOOSE 1

stNum:
RxGOOSE 1

sqNum:
R-RxGOOSE 1

IGMP:
CHANNEL 1

STATUS: n/a
CHANNEL 1 LOST

PACKETS:
CHANNEL 1 LOCAL

LOOPBCK STATUS: n/a
CHANNEL 1 REMOTE

LOOPBCK STATUS: n/a
CHANNEL 1

LOOP DELAY: 0.0 ms
CHNL 1 ASYMMETRY:

+0.0 ms
CHANNEL 2

STATUS: n/a
Range: 0 up to 4,294,967,295
0
Range: 0 up to 4,294,967,295
0
Range: On, Off
Off
Range: n/a, FAIL, OK
Range: 0 to 65535 in steps of 1. Reset count to 0
0 through the COMMANDS  CLEAR RECORDS menu.
Range: n/a, FAIL, OK
Range: n/a, FAIL, OK
Range: –10 to 10 ms in steps of 0.1
Range: n/a, FAIL, OK
L30 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES