GE L30 Instruction Manual page 628
Line current differential system
Hide thumbs
Also See for L30:
- Instruction manual (698 pages) ,
- Communications manual (532 pages) ,
- Communications manual (526 pages)
Table of Contents
Advertisement
CONVERT DEVICE SETTINGS
11
4.
Review the conversion report. The values of all settings that have been defaulted during conversion are not listed in
the conversion report; to find the value of a setting before conversion, inspect the device backup file made before
conversion.
In the example shown here, settings have been reset to factory defaults and several settings are new in firmware
version 7.6 under Settings > System Setup > Switches and Breakers.
5.
Change settings in the new file, for example by looking at the original file.
6.
Write the converted file to the device, for example by dragging and dropping from the Offline Window to the Online
Window.
7.
Check settings and operation.
11-6
Figure 11-5: Upgrade settings
Figure 11-6: Conversion report
L30 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
CHAPTER 11: MAINTENANCE
Advertisement
Table of Contents
