BT MultiJet 3000 Manual page 82

W ipi n g pr int no z zl e s a nd cont ac ts
If the print quality does not improve after cleaning
the print nozzles you may need to wipe dried ink from
the nozzles.
Dampen a clean cloth with water and gently wipe the
entire gold-coloured area, including the nozzles located
on the bottom of the ink cartridge.
When cleaning the colour cartridge wipe the nozzles in
one direction so the colours do not mix.
To dissolve any dried ink, hold the damp cloth against the
nozzles for about 3 seconds. Gently blot and allow the
gold-coloured area to dry.
Allow the gold-coloured area to dry
Wa r n i n g
D O N OT TO U C H T H E C O N TAC T S O F T H E
C ART R I D G E CA R R I ER
The contacts can be easily damaged and
electrostatic discharge may occur which will
damage the print control circuits.
P r e s e r v i n g p r in t c a r tr i d g e s
To ensure the longest life from your print cartridges and
optimum performance from your BT MultiJet 3000:
Keep a new print cartridge in its packaging until you are
ready to install it.
Do not remove a print cartridge except to replace, clean,
or store it in an air-tight container.
The print cartridge will not print correctly if it is removed
and left exposed to air for more than a couple of weeks.
When a print cartridge runs out of ink, leave it in your BT
MultiJet 3000 until you are ready to replace it as printing
with one of the print cartridge carriers empty could
shorten the working life of your printer.
We do not recommend refilling your cartridges. This can
affect print quality and could damage the BT MultiJet
3000. BT´s Limited Warranty does not cover repair of
failures or damage caused by a refilled cartridge.