BT MultiJet 3000 Manual page 45

Additional copier settings
These settings will remain active for a couple of minutes
after the last copy is printed. This allows you to continue
making copies with the same settings. If you stop
copying, they will revert to the default settings.
To adju st t he contr as t
You can make your copies lighter or darker.
Press Zo om / Contr ast/ Pa per Type
Adjust
Zoom
Contrast
display shows C O N T R A S T
Paper type
Use the Ad ju st buttons to decrease or increase
Adjust
the contrast. A smaller bar gives a lighter copy, a
larger bar gives a darker copy.
Press S t a r t to begin copying or select another
Yes option.
Press to stop and return to standby, the new
S t o p
setting will be retained. Press Stop again to
No
restore default setting.
To enla r ge or r e duce the copy
Normally, your copies will be the same size as the
original document (100%). The zoom feature lets you
reduce or enlarge your copies from 25% to 400% of the
original size.
Press Zo om / Contr ast/ Pa per Type
Adjust
display shows ZOOM 100%.
Zoom
Contrast
Paper type
until the
.
until the
Use the
Adjust A djus t but t on s
the size. Each press of the button changes the
zoom by 1%. Hold the button down to adjust the
size in steps of 10%.
Press or select another option.
S t a r t
Yes
Press to stop and return to standby, the new
S t o p
setting will be retained. Press
restore default setting.
No
paper
The quality of your copies will depend on the type of
paper you use. If you use glossy paper for photos or
transparencies, you should change the BT MultiJet 3000
paper setting.
To ch ange th e pa p er s et ti n g
Press Z o o m / C o n t r a s t / Pa p e r Ty p e
Adjust
display shows
PA P E R
Zoom
Contrast
Paper type
Use the buttons until the display shows
A djus t
Adjust
the type you want
(for Transparency) or
The Glossy paper type is only available when you have
set the printing mode to Colour. See page.
Press S t a r t or select another option.
Yes
Press to stop and return to standby, the new
S t o p
setting will be retained. Press Stop again to
No
restore default setting.
to decrease or increase
S t o p again to
Using different types of
until the
.
P L A I N , T R A N S P ,
G LO S S Y .