BT MultiJet 3000 Manual page 76

Error messages Descriptions
These error messages may
P r i n t e r E r r o r 7 9
appear if there is a
P r i n t e r E r r o r 8 1
P r i n t e r E r r o r 9 1 paper jam or if there is a
problem with the cartridge
P r i n t e r E r r o r 9 2
P r i n t e r E r r o r 9 3 carrier.
S c a n M o t o r E r r o r There may a problem
with the scanner.
The Scan macros have
Pr og r a m S c a n To s
not been set on the PC.
M e m o r y F u l l Current job(s) is using
up the memory.
P C N o t Av a i l a b l e You have initiated a task
that requires assistance
from the PC, but the PC
was not available.
The printer has
Power D ow n E r r o r
some problems.
Solutions
Remove the jammed paper in the printer. Otherwise call the Helpdesk.
Unplug your BT MultiJet 3000 from the mains power. Make sure the
scanner has been unlocked and re-connect the power.
Open Unimessage Pro and set the scan macros.
Wait until some of the pages have completed printing before copying
more pages.
Make Sure:
• Your PC is on and is not in suspend mode.• The USB cable is
connected to both the MultiJet 3000 and your computer.
Disconnect the mains power from the BT MultiJet 3000, then:
* Open the front cover to check for paper jams or other obstructions.
* Make sure the ink cartridges are correctly installed and
locked into place.
* Check the scanner is unlocked.
* Connect the power after finishing checking the above procedures.