BT MultiJet 3000 Manual page 8

Setting up
Planning the location of your BT MultiJet 3000
Place your BT MultiJet 3000 on a stable and flat surface.
D O N OT CONNECT TO T HE P OWER
S U P P LY Y E T.
1 U nlo ck t h e sc anner.
The scanner is locked to prevent damage during
shipping. Before connecting to the power supply it must
be unlocked.
Open the front compartment. In the upper left hand side
there is a sliding lever. To unlock the scanner, push the
lever inward until it stops.
Plea se N ote
If you do not unlock the scanner before the power is
turned on you will get an audible warning and the
message
UNLO CK SCA NNER
power off before unlocking the scanner.
2 Conne ct th e ma i n s power and US B ca ble
to th e BT Mul ti Jet 3000
U SB socke t
. You must turn the
M ains power s ocke t
If the BT MultiJet 3000 does not autostart press the
Power button.
3 Load pa pe r
You can load up to 100 sheets of 75gsm A4 paper.
To set the paper width, press the paper tray catches and
open the paper tray.
Pa p e r Tr ay C at ch e s
Load the paper into the tray. Squeeze the paper width
guide and slide it to the edge of the paper.
Pa per w idt h guide
Lift the paper tray and press it against the back of your
BT MultiJet 3000. Make sure both catches are securely in
place to avoid mis-feeds or paper jams.
Once the paper width guide is set, you can load paper
simply by sliding it into the paper tray.