Clinical Use - Philips IntelliVue TRx Instructions For Use Manual

Clinical Use

Auditory
Information
Signal Sound
Sound 1 beep
Sound 2 low-pitch
tone
Sound 3 alternating
pitch
repeated tone
Sound 4 beep beep
How Used
• Indicates successful Self-Test at power
on.
• Indicates successful SpO
measurement when measurement is
initiated at the transceiver.
• If the Check button is pressed, confirms
that the transceiver is in contact with the
Information Center (e.g., when transceiver
is brought back into range).
Indicates pulse detected during Spot Check
SpO measurement.
2
The pulse tone can be muted from the
Note—
Information Center. See "Patient Configurable
Settings in Telemetry Setup" on page 9-4.
Continuous tone to help you locate a missing
transceiver. Initiated by clicking Find Device in
the Telemetry Setup window. Tone continues
until Check button is pressed and held for 6
seconds, batteries are removed, or batteries
completely discharge.
• Indicates failed Self-Test at power on.
• Indicates failed SpO
measurement when measurement is
initiated at the transceiver.
• If it sounds when the Check button is
pressed, it indicates that the transceiver is
not in contact with the Information
Center.
Transceiver Controls
Audible Tones
Spot Check
2
Spot Check
2
3-11