Pairing with IntelliVue Patient
You can display measurement data from IntelliVue TRx and TRx+ Transceivers
on IntelliVue Patient Monitors. The transceiver and the monitor must be
assigned to the same patient; this is called "pairing". Once paired, the ECG
source is automatically detected at the Information Center. Should you
subsequently switch the ECG source between the two devices, the change is also
automatically detected at the Information Center.
There are two ways to transmit measurement data to the monitor: either by
directly connecting the transceiver to the monitor using an interface cable
(IntelliVue MP5 Patient Monitor only), or by pairing the transceiver with the
monitor at the Information Center. This chapter describes how to pair the
devices using a direct connection and how the devices operate in paired mode.
It includes the sections listed below. For additional information on monitor
operation, consult the MP5 Patient Monitor Instructions for Use. For additional
information on pairing other IntelliVue Patient Monitors at the Information
Center, consult the IntelliVue Information Center Instructions for Use.
•
Pairing with a Direct Connection to the MP5 Patient Monitor. . . . . . 10-2
•
Pairing at the Information Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-3
•
Alarm Behavior with Telemetry Overview . . . . . . . . . . . . . . . . . . . . 10-3
•
Paired Device Synchronized Alarm Settings . . . . . . . . . . . . . . . . . . . 10-7
Pairing of transceivers and IntelliVue Patient Monitors is not available
Note—
with IntelliVue Patient Monitors connected to the M3140 Information Center or
with IntelliVue Patient Monitors operating via a 1.4/2.4 GHz wireless
connection.
Monitors
Pairing with IntelliVue Patient Monitors
10
10-1