Configuring All Radio Network Communicators To The System; View Which Radio Network Communicators Are Online - EMS Firecell Programming Manual

11.0 CONFIGURING ALL RADIO NETWORK COMMUNICATORS TO THE SYSTEM

It is recommended that this feature is only used on an unconfigured system. When adding an
RNC to the system, this should be done individually. See
From Node 1s Front Screen:
Press the Enter Key to access the menus:
Press the Down Key to show:
Press the Enter Key to show:
Press the Down Key until Configure System:
Press the Enter Key to show:
Press the Down Key so
Press the Enter Key to show:
Waiting for screen to show Done:
Press the Back Key until front screen is shown:
In the above example, we are viewing node 01 on an 8 node network.

12.0 VIEW WHICH RADIO NETWORK COMMUNICATORS ARE ONLINE

From the Front Screen:
Press the Enter Key to access the menus:
Press the Down Key until the display shows:
Press the Enter Key to show:
Using the Up and Down key scrolls through the Nodes:
Press the Back Key until the front screen is shown:
EMS Group Head Office, Technology House, Sea Street, Herne Bay, Kent CT6 8JZ, England
Technical Helpline Tel: +44 (0) 1227 369570
FireCell Radio Network Communicator Programming Manual (Issue 2)
Y is shown:
Email:
Not Configured
Node Status
Node Setup
Set Node Number
Configure System
Configure
Configure
Searching ...01
Configured 01
Node 01 TOT08
Node 01 TOT08
Node Status
Network Status
Node 1 Healthy
Node 2 Healthy
Node 01 TOT08
enquiries@emsgroup.co.uk
MK137
N?
Y?
Website:www.emsgroup.co.uk
Page 12