All Other Radio Network Communicator Programming Steps - EMS Firecell Programming Manual

10.2 All Other Radio Network Communicator Programming Steps

The Control Panel 2's network card must fitted to the Panel ensuring that binary address 2 set on
board via the dil switches. For example:
Once the network card is fitted, a panel AUTOLEARN will be required. The panels will also require
programming. See Kentec Manuals for more information.
Once the panels are set up we can now program the Radio Network Communicator 2.
Radio Network Communicator 2 (node 2) can now be programmed in the following way:-
Setup Node Number
From the Front Screen:
Press the Enter Key to access the menus:
Press the Down Key to display:
Press the Enter Key to show:
Press the Enter Key to display:
Press the Up Key to show:
Press the Enter Key to display:
Press the Back Key to show:
Press the Down KEY to show:
Press the Enter Key to show:
Press the Down Key so
Press the Enter Key:
Using the Up, Down and Enter Key,
type in the Site Node 1 ID:
Note: This number should have been previously noted at Node 1 and from the Barcode on Radio
Network Communicator 1.
Press the Down Key so
Press the Enter Key:
Press the Back Key until the front screen is shown:
Note: Repeat this on all Radio Network Communicators across the system to ensure all Site IDs
match and also Network Card & Node addresses are set accordingly between 3 and 8.
EMS Group Head Office, Technology House, Sea Street, Herne Bay, Kent CT6 8JZ, England
Technical Helpline Tel: +44 (0) 1227 369570
FireCell Radio Network Communicator Programming Manual (Issue 2)
Y is shown:
Y is shown:
Email:
Un-programmed
Node Status
Node Setup
Set Node Number
New Num= 01 Y?
New Num= 02 Y?
Updated
Set Node Number
Set Site ID
ID= 00000 Chg N?
ID= 00000 Chg Y?
ID= 00000 Chg N?
ID= 0C03B Chg Y?
ID= 0C03B Chg N?
Updated
Not Configured
enquiries@emsgroup.co.uk
MK137
Website:www.emsgroup.co.uk
Page 11