System Board Interconnects; Midplane; Figure 22. Passive Midplane Board - Intel SR1625UR Technical Product Specification

System Board Interconnects

5. System Board Interconnects
System boards within the system include two types of midplanes, a bridge board, a hard drive
backplane, a PCI riser board, and three types of control panels. This chapter describes the
interconnect features of each and defines the pin-outs for each of their connectors. Functional
details of each system board are described in later chapters.
5.1

Midplane

The midplane is designed and used, along with that of the bridge board and hot-swap
backplane, to improve cable routing within the system. The midplane is the key system board of
the system. It serves as the primary interface between the server board, hot-swap backplane,
and control panel. Two midplanes are offered for this system: a passive SATA/SAS, and an
active SAS/SAS RAID.
The passive midplane is a simple pass through from the backplane to the SATA connectors on
the server board or SAS/SATA connectors on an add-in card.
The following diagram shows the location for each connector found on the passive midplane
board:
A
B
C
D
E
32
Power Connector
Fan 6 Connector
Fan 5 Connector
SAS/SATA Connectors
Bridge Board Connector

Figure 22. Passive Midplane Board

Intel order number E47487-007
Intel® Server System SR1625UR TPS
F Fan 4 Connector
G Fan 3 Connector
H Fan 1 Connector
I Fan 2 Connector
J Backplane Connector
Revision 1.5