HP 5830 Series Configuration Manual page 44

Step
Enable command accounting.
6.
7. Exit to system view.
8. Apply an AAA authentication
scheme to the intended domain.
9. Create a local user and enter
local user view.
10. Set a password.
11. Specify the command level of
the local user.
Specify Telnet service for the
12.
local user.
13. Exit to system view.
Command
command accounting
quit
a. Enter ISP domain view:
domain domain-name
b. Apply an AAA scheme
to the domain:
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
c. Exit to system view:
quit
local-user user-name
password { cipher | simple }
password
authorization-attribute level
level
service-type telnet
quit
37
Remarks
Optional.
By default, command accounting is
disabled. The accounting server
does not record the commands
executed by users.
Command accounting allows the
HWTACACS server to record all
executed commands that are
supported by the device,
regardless of the command
execution result. This function helps
control and monitor user behaviors
on the device. If command
accounting is enabled and
command authorization is not
enabled, every executed command
is recorded on the HWTACACS
server. If both command
accounting and command
authorization are enabled, only the
authorized and executed
commands are recorded on the
HWTACACS server.
N/A
Optional.
By default, local authentication is
used.
For local authentication, configure
local user accounts.
For RADIUS or HWTACACS
authentication, configure the
RADIUS or HWTACACS scheme
on the device and configure
authentication settings (including
the username and password) on the
server.
For more information about AAA
configuration, see Security
Configuration Guide.
By default, no local user exists.
By default, no password is set.
Optional.
By default, the command level is 0.
By default, no service type is
specified.
N/A