Download Print this page

HP 5830 Series Configuration Manual: Configuring User Privilege And Command Levels; Configuring A User Privilege Level

Hide thumbs

Advertisement

# Use | include Vlan in the display ip routing-table command to filter in route entries that contain Vlan.
<Sysname> display ip routing-table | include Vlan
Routing Tables: Public
Destination/Mask
192.168.1.0/24

Configuring user privilege and command levels

To avoid unauthorized access, the device defines the user privilege levels and command levels in
7. User privilege levels correspond to command levels. A user who has been logged in with a specific
privilege level can use only the commands at that level or lower levels.
All commands are categorized into four levels: visit, monitor, system, and manage, and are identified
from low to high, respectively by 0 through 3.
Table 7 Command levels and user privilege levels
Level
Privilege
0
Visit
1
Monitor
2
System
3
Manage

Configuring a user privilege level

If the authentication mode on a user interface is scheme, configure a user privilege level for the user
interface's users through the AAA module or directly on the user interface. For SSH users who use
public-key authentication, the user privilege level configured directly on the user interface always takes
effect. For other users, the user privilege level configured in the AAA module has priority over the one
configured directly on the user interface.
If the authentication mode on a user interface is none or password, configure the user privilege level
directly on the user interface.
Proto
Pre
Cost
Direct 0
0
Default set of commands
Includes commands for network diagnosis and commands for accessing an external
device. Configuration of commands at this level cannot survive a device restart. Upon
device restart, the commands at this level are restored to the default settings.
Commands at this level include ping, tracert, telnet and ssh2.
Includes commands for system maintenance and service fault diagnosis. Commands at
this level are not saved after being configured. After the device is restarted, the commands
at this level are restored to the default settings.
Commands at this level include debugging, terminal, refresh, and send.
Includes service configuration commands, including routing configuration commands and
commands for configuring services at different network levels.
By default, commands at this level include all configuration commands except for those at
manage level.
Includes commands that influence the basic operation of the system and commands for
configuring system support modules.
By default, commands at this level involve the configuration commands of file system, FTP,
TFTP download, user management, level setting, and parameter settings within a system,
which are not defined by any protocols or RFCs.
NextHop
192.168.1.42
13
Interface
Vlan999
Table

Advertisement

   Also See for HP 5830 Series

   Related Manuals for HP 5830 Series

Comments to this Manuals

Symbols: 0
Latest comments: