Table of Contents
Advertisement
®
ABB i-bus
KNX
Device technology
Supplied state
The device is supplied with the physical address 15.15.255. The application is pre-installed. Hence,
only group addresses and parameters need to be loaded during commissioning.
The complete application can be reloaded if required. Downloads may take longer after a change of
application or a discharge.
Physical address allocation
The assignment and programming of the physical address are carried out in ETS.
The device features a Programming button for assignment of the physical address. The red Programming
LED
address or the Programming button is pressed again.
Download response
Because of the complexity of the device, the progress bar for the download may take up to 90 seconds to
appear depending on the PC used.
In certain cases the device may be inaccessible for up to 10 seconds after a download.
Cleaning
The voltage supply to the device must be switched off before cleaning. If devices become dirty, they can
be cleaned using a dry cloth or a cloth dampened with a soapy solution. Never use corrosive agents or
solutions.
Maintenance
The device is maintenance-free. In the event of damage (e.g. during transport and/or storage), do not carry
out any repairs.
12 2CDC508171D0201 | SUG/U 1.1
lights up after the button has been pressed. It goes off as soon as ETS has assigned the physical
Advertisement
Table of Contents
