Precautions In Disassembly And Reassembly Of Battery Charger - Hitachi CL 10D2 Technical Data And Service Manual

(g) Mounting the Cover [38] or the Cutter Ass'y M8 [52]
Remove the Battery [16], and fasten the Cover [38] with the two Machine Screws (W/Washers) M4 x 20
(Black) [37].
The Cutter Ass'y M8 [52] must be mounted in the proper directions. As shown in Fig. 43, they must be
mounted so that if the groove in the side of one cutter is present (Yes), the groove in the side of the outer
cutter is not present (No). After mounting direction has been confirmed, fasten the cutters with the two
Special Bolts M5 x 9 [50].
[37]
[38]
(h) Fasten the Stud Guide Ass'y [46] with the Bolt W3/8 x 75 [48] and Spring Washer M10 [47] as shown in
Fig. 19.
(i) Tightening torques are as follows:
Tapping Screw (W/Flange) D4 x 20 (Black) [8]
Machine Screw (W/Washers) (Black) M4 x 20 [37]
Seal Lock Screw (W/SP. Washer) M4 x 12 [40]
Tapping Screw (W/Flange) D5 x 25 (Black) [17]
Tapping Screw D5 x 35 [43]
Hex. Socket Hd. Bolt M5 x 12 [34]
Special Bolt M5 x 9 [50]
Lock Nut M12 [45]
Bolt W3/8 x 75 [48]

8-3. Precautions in Disassembly and Reassembly of Battery Charger

Refer to the Technical Data and Service Manual for precautions in disassembly and reassembly of the Model
UC 14YF2 battery charger.
[50]
Groove is
not present.
Groove is
present.
Fig. 43
Size
M10
M8
[52]
M6
[51]
W3/8"
1.96 0.49 N•m (20
1.76 0.49 N•m (18
1.76 0.49 N•m (18
3.43 0.49 N•m (35
3.43 0.49 N•m (35
5.88 1.47 N•m (60
5.88 1.47 N•m (60
34.3 7.35 N•m (350 75 kgf•cm, 304.5
15.68 3.92 N•m (160
--- 27 ---
Attachment
[52]
[42]
[51]
[50]
[44]
[51]
[52]
[52]
[42]
[50]
[52] [44]
5 kgf•cm, 17.4 4.3 in-lbs.)
5 kgf•cm, 15.7 4.3 in-lbs.)
5 kgf•cm, 15.7 4.3 in-lbs.)
5 kgf•cm, 30.5 4.3 in-lbs.)
5 kgf•cm, 30.5 4.3 in-lbs.)
15 kgf•cm, 52.2 13 in-lbs.)
15 kgf•cm, 52.2 13 in-lbs.)
65 in-lbs.)
40 kgf•cm, 139.2
[50]
[50]
35 in-lbs.)