Mounting On Din Rails - Siemens SIMATIC IPC427D Operating Instructions Manual

Installing and connecting the device
3.2 Installing the device
3.2.2.2

Mounting on DIN rails

Requirement
● DIN rail, 35 mm standard profile
The DIN rail is installed at the installation site.
Note
Ensure that the wall or ceiling can hold four times the total weight of the device including DIN
profile rail and additional expansion cards. See Mounting instructions (Page 33).
Procedure
Mounting
1. Place the device and rail clip on the up-
per edge of the standard profile rail at the
position shown.
2. Push down the device. Once the rail clip
slides over the bottom edge of the DIN
rail, push the device onto the rail until it
engages with an audible click.
Removing
1. Push down the device until it is released by the rail clips.
2. Swing the device out of the standard profile rail.
3. Lift the device up and off.
36
Operating Instructions, 05/2017, A5E31347215-AB
SIMATIC IPC427D