Pitney Bowes DM500 Operator's Manual page 99

DM500™ and DM550™ Digital Mailing System Operating Guide
Connecting
Your Postage
Meter to an
Analog Phone
Line
continued
SV60890 Rev. G
Connecting Your Mailing System - Remote Analog Phone
Line
If you need to connect to an analog phone line that is not located near
your mailing system, you can remove the IntelliLink® Control Center and
move it to a location near the analog phone line. At the remote location,
plug one end of the AC Adapter (P/N 1C85005) into the back of the control
center and the other end into an AC outlet.
To remove the control center and move it to another location:
1. Turn off the power to the mailing system.
2. Pull the blue lever at the right
of the control center towards
you.
3. Slide the control center for-
ward to remove it.
4. Take the control center (and external modem) to where the analog
phone line is.
5. Depending on the PCN number of your IntelliLink® Control Center,
connect the telephone cord (AWG 26) from either the external modem,
or the internal analog connector to the analog telephone line.
Connect the A/C Adapter (P/N 1C85005) to the back of the control cen-
ter and plug it into an AC outlet. Refer to the figure below.
AC Adapter plugged
into IntelliLink® Control
Center
Internal analog line for
PCN 1DXX only
Telephone Cord for
Analog Line
(26 AWG) External Modem
External USB
Modem Cable
for PCN 1CXX
only
6-5