Powering On The Switch - HP FlexFabric 12900 series Installation Manual

Figure 33 Setting terminal emulation in Switch Properties dialog box

Powering on the switch

Before powering on the switch, confirm the following:
• You know where the emergency power-off switch for the equipment room is located.
The switch has been securely mounted.
•
All the cards have been correctly installed.
•
The unused slots have been installed with filler panels.
•
All the network cables, fibers, power cables, and grounding cables have been correctly connected.
•
• The input power voltage meets the requirement of the switch.
The console cable is correctly connected, the terminal or PC used for configuration has started, and
•
the configuration parameters have been set.
To power on the switch, turn on the power source of the switch.
The following is a sample output you can see on the terminal:
System is starting...
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing.........Done.
****************************************************************************
*
* BootWare, Version 1.06
42
*
*