Connecting An Ac Power Cable - HP FlexFabric 12900 series Installation Manual

Figure 23 Installing the power supply
(1) Open the panel of the power supply
(3) Close the panel of the power supply

Connecting an AC power cable

WARNING!
Make sure each power cable has a separate circuit breaker.
•
• Before connecting the power cable, make sure the circuit breaker on the power cable is switched off.
The power receptacles of a 12910 AC switch are located in the power distribution box area at the lower
part of the rear panel. They are numbered as PWR1 through PWR8. Make sure the numbers of the power
receptacles are the same the slot numbers of the power supplies that have been installed.
To connect the power cable:
1. Plug the power cable into the power receptacle of the power supply (PWR1, for example).
2. Use two cable ties to secure the power cable to the power cable bracket.
Prepare cable ties yourself.
1
3
(2) Insert the power supply into the slot
(4) Push the latch inward
29
2
4