Removing The Power Cable Bracket - HP FlexFabric 12900 series Installation Manual

To remove the chassis from the rack:
1. Prepare the wooden pallet base, carton, and packing bag of the chassis. Make sure they are clean,
dry, and not damaged.
2. Put the wooden pallet base to a proper place.
3. As shown in callout 1 in
mounting brackets to the rack.
4. As shown in callout 2 in
slide rails. When most part of the chassis is removed from the slide rails, lift up the chassis by
holding the handles at the chassis sides to completely remove the chassis from the rack.
5. Put the chassis onto the wooden pallet base.
Figure 81 Removing the chassis from the rack
(1) Loosen the captive screws that attach the mounting brackets to the rack
(2) Slide the chassis outwards along the slide rails

Removing the power cable bracket

Before you repack the 12910 AC switch, remove the power cable bracket. The power cable bracket of the
12910 AC is attached to the power distribution box on the rear panel.
To remove the power cable bracket:
1. Prepare the packing bag and box of the power cable bracket. Make sure they are clean, dry, and
not damaged.
2. Use a screwdriver to loosen the screws that attach the power cable bracket to the chassis and
remove the power cable bracket from the chassis.
Figure 81, use a Phillips screwdriver to loosen the screws that attach the
Figure 81, use at least four persons to slide the chassis outwards along the
111