HP FlexFabric 12900 series Installation Manual page 65

4. Press the buttons on the ejector levers and then move the ejector levers outward to separate the
switching fabric module from the backplane, as shown in callout 2 on
Figure 42 Loosening screw and moving the eject levers outward
(1) Loosen the captive screw
(3) Move the ejector levers outwards
Slowly move the switching fabric module outward. Holding both sides of the switching fabric
5.
module, pull the switching fabric module out of the slot along the slide rails, as shown in
(2) Press the buttons on the ejector levers
59
Figure 42.
Figure 43.