Replacing A Switching Fabric Module - HP FlexFabric 12900 series Installation Manual
Hide thumbs
Also See for FlexFabric 12900 series:
- Command reference manual (268 pages) ,
- Configuration manual (243 pages) ,
- Troubleshooting manual (75 pages)
Table of Contents
Advertisement
Figure 41 Pulling out an LPU
6.
Put the removed LPU on the antistatic mat.
7.
Install a new LPU. For the installation procedures, see
Replacing a switching fabric module
1.
Prepare an antistatic mat to place the removed switching fabric module.
2.
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded. For more information, see
3.
Use a Phillips screwdriver to loosen the captive screws on the switching fabric module, as shown
in callout 1 on
Figure
42.
"Installing
"Installing
FRUs."
58
FRUs."
Advertisement
Table of Contents
Troubleshooting
