Powering On The Switch; Verification Before Power-On - HP 5920 Series Installation Manual

Powering on the switch

Verification before power-on

Before powering on the switch, verify that:
The power cord is properly connected.
•
• The input power voltage meets the requirement of the switch.
The console cable is properly connected, the terminal or PC used for configuration has started, and
•
the configuration parameters have been set.
Powering on the switch
Power on the switch (for example, an HP 5900AF-48XG-4QSFP+ switch), and you can see the following
information:
Starting......
********************************************************************************
*
*
*
********************************************************************************
Copyright (c) 2010-2011 Hewlett-Packard Development Company, L.P.
Creation Date
CPU Clock Speed : 1000MHz
Memory Size
Flash Size
CPLD Version
PCB Version
Mac Address
Press Ctrl-B to enter Extended Boot menu...1
Press Ctrl + B at the prompt within one second to access the Boot menu, or wait for the system to
automatically start up.
NOTE:
The system has two startup modes: full startup and fast startup. By default, the system starts up in fast mode
and the waiting time is one second. If you set the startup mode to full, the waiting time is five seconds. To
change the startup mode, see
If you press Ctrl + B within one second, the following Boot menu appears:
•
BOOT
1. Download image to flash
HP 5900AF-48XG-4QSFP+ Switch BOOTROM, Version 112
: Nov 14 2011,16:32:02
: 2048MB
: 512MB
: 002/002
: Ver.A
: 00E0FC005800
"Changing the startup
MENU
mode."
27
*
*
*