Table of Contents
Advertisement
Figure 31 Setting terminal emulation in Switch Properties dialog box
Powering on the switch
Before powering on the switch, verify that the following conditions are met:
•
The power cord is correctly connected.
The input power voltage meets the requirement of the switch.
•
The console cable is correctly connected.
•
The configuration terminal (a PC, for example) has started, and its serial port settings are consistent
•
with the console port settings on the switch.
Power on the switch. During the startup process, you can access Boot ROM menus to perform tasks such
as software upgrade and file management. The Boot ROM interface and menu options differ with
software versions. For more information about Boot ROM menu options, see the software-matching
release notes for the device.
After the startup completes, you can access the CLI to configure the switch.
For more information about the configuration commands and CLI, see HP FlexFabric 5930 Switch Series
Configuration Guides and HP FlexFabric 5930 Switch Series Command References.
27
Advertisement
Table of Contents
