Step 1. Unplug the power cable from the power supply.
Step 2. Disconnect the ground cable from the grounding lug near the power
Step 3. Use either a flat-bladed or Torx T-10 screwdriver and loosen the four
Step 4. Pull the power supply out of the opening, lifting it up while pulling.
Figure 4-1
Removing the Power Supply
connector on the face plate of the power supply.
captive screws connecting the existing power supply.
Removing the Power Supply from the Switch Chassis
Chapter 4
Replacing the DC Power Supply
Replacing the DC Power Supply
Retaining Screws
33