Dell S4048–ON Configuration Manual page 284

3
4
5
6
7
Oper status is init
Conf TLV Tx Status is disabled
Traffic Class TLV Tx Status is disabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error Traffic Class TLV
Pkts
The following table describes the show interface ets detail command fields.
Table 22. show interface ets detail Command Description
Field
Interface
Maximum Supported TC Group
Number of Traffic Classes
Admin mode
Admin Parameters
Remote Parameters
Local Parameters
Operational status (local port)
ETS DCBx Oper status
State Machine Type
Conf TLV Tx Status
ETS TLV Statistic: Input Conf TLV pkts
ETS TLV Statistic: Output Conf TLV pkts
ETS TLV Statistic: Error Conf TLV pkts
284 Data Center Bridging (DCB)
13% ETS
12% ETS
12% ETS
12% ETS
12% ETS
Description
Interface type with stack-unit and port number.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
ETS mode: on or off.
ETS configuration on local port, including priority groups, assigned
dot1p priorities, and bandwidth allocation.
ETS configuration on remote peer port, including Admin mode
(enabled if a valid TLV was received or disabled), priority groups,
assigned dot1p priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for DCBx exchange, the
Willing bit received in ETS TLVs from the remote peer is included.
ETS configuration on local port, including Admin mode (enabled
when a valid TLV is received from a peer), priority groups, assigned
dot1p priorities, and bandwidth allocation.
Port state for current operational ETS configuration:
• Init: Local ETS configuration parameters were exchanged with
peer.
• Recommend: Remote ETS configuration parameters were
received from peer.
• Internally propagated: ETS configuration parameters were
received from configuration source.
Operational status of ETS configuration on local port: match or
mismatch.
Type of state machine used for DCBx exchanges of ETS
parameters:
• Feature: for legacy DCBx versions
• Asymmetric: for an IEEE version
Status of ETS Configuration TLV advertisements: enabled or
disabled.
Number of ETS Configuration TLVs received.
Number of ETS Configuration TLVs transmitted.
Number of ETS Error Configuration TLVs received.