Important Points To Remember; Configuration Task List For Route Maps - Dell S4048–ON Configuration Manual

Dell(conf-policy-map-in)#service-queue 4 class-map cmap2
Dell(conf-policy-map-in)#exit
Dell(conf)#interface te 10/1
Dell(conf-if-te-10/1)#service-policy input pmap

Important Points to Remember

• For route-maps with more than one match clause:
• Two or more match clauses within the same route-map sequence have the same match commands (though the values are
different), matching a packet against these clauses is a logical OR operation.
• Two or more match clauses within the same route-map sequence have different match commands, matching a packet against
these clauses is a logical AND operation.
• If no match is found in a route-map sequence, the process moves to the next route-map sequence until a match is found, or there are
no more sequences.
• When a match is found, the packet is forwarded and no more route-map sequences are processed.
• If a continue clause is included in the route-map sequence, the next or a specified route-map sequence is processed after a match
is found.

Configuration Task List for Route Maps

Configure route maps in ROUTE-MAP mode and apply the maps in various commands in ROUTER RIP and ROUTER OSPF modes.
The following list includes the configuration tasks for route maps, as described in the following sections.
• Create a route map (mandatory)
• Configure route map filters (optional)
• Configure a route map for route redistribution (optional)
• Configure a route map for route tagging (optional)
Creating a Route Map
Route maps, ACLs, and prefix lists are similar in composition because all three contain filters, but route map filters do not contain the permit
and deny actions found in ACLs and prefix lists.
Route map filters match certain routes and set or specific values.
To create a route map, use the following command.
• Create a route map and assign it a unique name. The optional permit and deny keywords are the actions of the route map.
CONFIGURATION mode
route-map map-name [permit | deny] [sequence-number]
The default is permit.
The optional seq keyword allows you to assign a sequence number to the route map instance.
Configured Route Map Examples
The default action is permit and the default sequence number starts at 10. When you use the keyword deny in configuring a route map,
routes that meet the match filters are not redistributed.
To view the configuration, use the show config command in ROUTE-MAP mode.
Dell(config-route-map)#show config
!
route-map dilling permit 10
Dell(config-route-map)#
114 Access Control Lists (ACLs)