Vlt Port Delayed Restoration; Pim-Sparse Mode Support On Vlt - Dell S4048–ON Configuration Manual

Hide thumbs Also See for S4048–ON:

Table of Contents

VLT Port Delayed Restoration

When a VLT node boots up, if the VLT ports have been previously saved in the start-up configuration, they are not immediately enabled.

To ensure MAC and ARP entries from the VLT per node are downloaded to the newly enabled VLT node, the system allows time for the

VLT ports on the new node to be enabled and begin receiving traffic.

The delay-restore feature waits for all saved configurations to be applied, then starts a configurable timer. After the timer expires, the

VLT ports are enabled one-by-one in a controlled manner. The delay between bringing up each VLT port-channel is proportional to the

number of physical members in the port-channel. The default is 90 seconds.

To change the duration of the configurable timer, use the delay-restore command.

If you enable IGMP snooping, IGMP queries are also sent out on the VLT ports at this time allowing any receivers to respond to the queries

and update the multicast table on the new node.

This delay in bringing up the VLT ports also applies when the VLTi link recovers from a failure that caused the VLT ports on the secondary

VLT peer node to be disabled.

The designated router functionality of the PIM Sparse-Mode multicast protocol is supported on VLT peer switches for multicast sources

and receivers that are connected to VLT ports.

VLT peer switches can act as a last-hop router for IGMP receivers and as a first-hop router for multicast sources.

Virtual Link Trunking (VLT)