Dell S4048–ON Configuration Manual page 41

CLI Command Mode
ROUTER RIP
SPANNING TREE
TRACE-LIST
CLASS-MAP
CONTROL-PLANE
DHCP
DHCP POOL
ECMP
EIS
FRRP
LLDP
LLDP MANAGEMENT INTERFACE
LINE
MONITOR SESSION
OPENFLOW INSTANCE
PORT-CHANNEL FAILOVER-GROUP
PRIORITY GROUP
PROTOCOL GVRP
QOS POLICY
SUPPORTASSIST
VLT DOMAIN
VRRP
u-Boot
UPLINK STATE GROUP
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
Prompt
Dell(conf-router_rip)#
Dell(config-span)#
Dell(conf-trace-acl)#
Dell(config-class-map)#
Dell(conf-control-cpuqos)#
Dell(config-dhcp)#
Dell(config-dhcp-pool-name)#
Dell(conf-ecmp-group-ecmp-
group-id)#
Dell(conf-mgmt-eis)#
Dell(conf-frrp-ring-id)#
Dell(conf-lldp)# or Dell(conf-if
—interface-lldp)#
Dell(conf-lldp-mgmtIf)#
Dell(config-line-console) or
Dell(config-line-vty)
Dell(conf-mon-sess-sessionID)#
Dell(conf-of-instance-of-id)#
Dell(conf-po-failover-grp)#
Dell(conf-pg)#
Dell(config-gvrp)#
Dell(conf-qos-policy-out-ets)#
Dell(support-assist)#
Dell(conf-vlt-domain)#
Dell(conf-if-interface-type-
slot/port-vrid-vrrp-group-id)#
Dell=>
Dell(conf-uplink-state-group-
groupID)#
Access Command
router rip
protocol spanning-tree 0
ip trace-list
class-map
control-plane-cpuqos
ip dhcp server
pool (DHCP Mode)
ecmp-group
management egress-interface-
selection
protocol frrp
protocol lldp (CONFIGURATION or
INTERFACE Modes)
management-interface (LLDP Mode)
line console orline vty
monitor session
openflow of-instance
port-channel failover-group
priority-group
protocol gvrp
qos-policy-output
support-assist
vlt domain
vrrp-group
Press any key when the following line
appears on the console during a system
boot: Hit any key to stop
autoboot:
uplink-state-group
Configuration Fundamentals 41