Enabling Pause Frames - Dell S4048–ON Configuration Manual

An Ethernet interface starts to send pause frames to a sending device when the transmission rate of ingress traffic exceeds the egress
port speed. The interface stops sending pause frames when the ingress rate falls to less than or equal to egress port speed.
The globally assigned 48-bit Multicast address 01-80-C2-00-00-01 is used to send and receive pause frames. To allow full-duplex flow
control, stations implementing the pause operation instruct the MAC to enable reception of frames with destination address equal to this
multicast address.
The PAUSE frame is defined by IEEE 802.3x and uses MAC Control frames to carry the PAUSE commands. Ethernet pause frames are
supported on full duplex only.
If a port is over-subscribed, Ethernet Pause Frame flow control does not ensure no-loss behavior.
Restriction: Ethernet Pause Frame flow control is not supported if PFC is enabled on an interface.
Control how the system responds to and generates 802.3x pause frames on Ethernet interfaces. The default is rx off tx off. INTERFACE
mode. flowcontrol rx [off | on] tx [off | on]| [monitor session-ID]
Where:
rx on: Processes the received flow control frames on this port.
rx off: Ignores the received flow control frames on this port.
tx on: Sends control frames from this port to the connected device when a higher rate of traffic is received.
tx off: Flow control frames are not sent from this port to the connected device when a higher rate of traffic is received.
monitor session-ID: Enables mirror flow control frames on this port.
Changes in the flow-control values may not be reflected automatically in the show interface output. To display the change, apply the
new flow-control setting, shutdown the interface using the shutdown command, enable the interface using the no shutdown
command, and use the show interface command to verify the changes.

Enabling Pause Frames

Enable Ethernet pause frames flow control on all ports on a chassis or a line card. If not, the system may exhibit unpredictable behavior.
NOTE: Changes in the flow-control values may not be reflected automatically in the show interface output. As a workaround,
apply the new settings, execute shut then no shut on the interface, and then check the running-config of the port.
NOTE: If you disable rx flow control, Dell Networking recommends rebooting the system.
The flow control sender and receiver must be on the same port-pipe. Flow control is not supported across different port-pipes.
To enable pause frames, use the following command.
• Control how the system responds to and generates 802.3x pause frames on the Ethernet ports.
INTERFACE mode
flowcontrol {rx [off | on] tx [off | on] [negotiate] | monitor session-ID}
• rx on: enter the keywords rx on to process the received flow control frames on this port.
• rx off: enter the keywords rx off to ignore the received flow control frames on this port.
• tx on: enter the keywords tx on to send control frames from this port to the connected device when a higher rate of traffic is
received.
• tx off: enter the keywords tx off so that flow control frames are not sent from this port to the connected device when a
higher rate of traffic is received.
Interfaces 423