Udp Helper With No Configured Broadcast Addresses; Troubleshooting Udp Helper - Dell S4048–ON Configuration Manual

Hide thumbs Also See for S4048–ON:

Table of Contents

Figure 54. UDP Helper with Configured Broadcast Addresses

UDP Helper with No Configured Broadcast Addresses

The following describes UDP helper with no broadcast addresses configured.

If the incoming packet has a broadcast destination IP address, the unaltered packet is routed to all Layer 3 interfaces.

If the Incoming packet has a destination IP address that matches the subnet broadcast address of any interface, the unaltered packet is

routed to the matching interfaces.

To display debugging information for troubleshooting, use the debug ip udp-helper command.

Example of the debug ip udp-helper Command

Dell(conf)# debug ip udp-helper

01:20:22: Pkt rcvd on Te 5/1 with IP DA (0xffffffff) will be sent on Te 5/2 Te 5/3 Vlan 3

01:44:54: Pkt rcvd on Te 7/1 is handed over for DHCP processing.

When using the IP helper and UDP helper on the same interface, use the debug ip dhcp command.

Example Output from the debug ip dhcp Command

Packet 0.0.0.0:68 -> 255.255.255.255:67 TTL 128

2005-11-05 11:59:35 %RELAY-I-PACKET, BOOTP REQUEST (Unicast) received at interface

172.21.50.193 BOOTP Request, XID = 0x9265f901, secs = 0 hwaddr = 00:02:2D:8D:46:DC,

giaddr = 0.0.0.0, hops = 2

2005-11-05 11:59:35 %RELAY-I-BOOTREQUEST, Forwarded BOOTREQUEST for 00:02:2D:8D:46:DC

to 137.138.17.6

2005-11-05 11:59:36 %RELAY-I-PACKET, BOOTP REPLY (Unicast) received at interface

194.12.129.98 BOOTP Reply, XID = 0x9265f901, secs = 0 hwaddr = 00:02:2D:8D:46:DC,

giaddr = 172.21.50.193, hops = 2

2005-07-05 11:59:36 %RELAY-I-BOOTREPLY, Forwarded BOOTREPLY for 00:02:2D:8D:46:DC to

128.141.128.90 Packet 0.0.0.0:68 -> 255.255.255.255:67 TTL 128

IPv4 Routing