Simatic Rf600 - Siemens SIMATIC RF600 System Manual

Antenna connections
Power supply
Digital I/O interface
Digital inputs
Digital outputs
Ethernet
Thermal and electrical properties
Power supply
● Permitted range
Power supply
20 V input voltage on the reader, typical
24 V input voltage on the reader, typical
30 V input voltage on the reader, typical
Power supply
20 V input voltage on the reader, typical
24 V input voltage on the reader, typical
30 V input voltage on the reader, typical
Rampup time
All supply and signal voltages must be safety extra low voltage (SELV/PELV according to EN 60950)
1)
24 V DC power supply: safe (electrical) isolation of extra-low voltage (SELV / PELV acc. to EN 60950)
Mechanical environmental conditions
Shock resistant to EN 60068-2-27
Vibration EN 60068-2-6
Climatic Conditions
Ambient temperature in operation
Ambient temperature for transport and storage
The values for shock and vibration are maximum values and must not be applied continuously.
1)
EMC & approvals/conformity for ETSI variant
Electromagnetic compatibility
Approvals/Conformity

SIMATIC RF600

System Manual, 06/2010, J31069-D0171-U001-A10-7618
4x RTNC connector
1 x plug (4-pin M12)
1 x socket (12-pin M12)
4
4 (500 mA each; max. 1500 mA in total)
RJ45 TCP/IP (Push-Pull) 10/100 Mbit/s
20 V DC... 30 V°DC
Current consumption
(in standby mode, no
transmit power)
140 mA
120 mA
100 mA
Current consumption
(at 1000 mW ERP)
530 mA
450 mA
370 mA
19 s
50 g
1
20 g
1
-25 °C to +55 °C
(a 10-minute warm-up time must be observed at an operating
temperature below -20 °C)
-40 °C to +85 °C
ETSI EN 301 489-1 / -3
● Radio to R&TTE guideline EN 301 489
● CE
● ETSI EN 302-208 V1.2.1
● Reader degree of protection acc. to EN 60529 (IP65)
● RoHS-compliant according to EU Directive 2002/95/EC
● EN302208 -1 & -2
● Human exposure
Draft Version 02.06.2010
5.3 RF670R reader
1
Power requirement
(in standby mode, no
transmit power)
2.8 W
2.88 W
3.0 W
Power requirement
(at 1000 mW ERP)
10.6 W
10.8 W
11.1 W
Readers
129