Ic-Fcb Information - Siemens SIMATIC RF600 System Manual

Note
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
FCC Notice
To comply with FCC part 15 rules in the United States, the system must be professionally
installed to ensure compliance with the Part 15 certification.
It is the responsibility of the operator and professional installer to ensure that only certified
systems are deployed in the United States. The use of the system in any other combination
(such as co-located antennas transmitting the same information) is expressly forbidden.
FCC Exposure Information
To comply with FCC RF exposure compliance requirements, the antennas used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter.
5.4.7.3

IC-FCB information

Siemens SIMATIC RF660R: 6GT2811-0AA01
IC: 267X-RF660
Industry Canada NoticeTo reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that permitted for successful communication.
This device has been designed to operate with the SIMATIC RF620A antenna 902-928 as well
as the SIMATIC RF660A antenna 902-928 listed below, and having a maximum gain of 5,5 dBi.
Other antennas or antennas having a gain greater than 5,5 dBi are strictly prohibited for use
with this device.
The required antenna impedance is 50 Ohms.
SIMATIC RF600
System Manual, 06/2010, J31069-D0171-U001-A10-7618
Draft Version 02.06.2010
Readers
5.4 RF660R reader
151