Network Setup - LG LDV-S504 Owner's Manual

Network setup

TCP/IP Settings
The DHCP, IP Address, Subnet Mask, Gateway,
Primary DNS, Secondary DNS, TCP/IP Port No. and
Web Server Port No. option setting are not available
in the client program. You can set these options in
the system menu of the DVR.
Bandwidth : Enter the Bandwidth to adjust the
data traffic (1~100Mbps).
Mail Settings
Set the Mail options.
Notification : When you mark up the
Notification option, notify the user about unit
operating information by E-mail according to
your notification settings.
SMTP Server : Enter the SMTP Server
address.
SMTP Port No. : Enter the SMTP Port
Number. Typically the TCP port used for
SMTP is 25. However in some cases it is bet-
ter to change this port number for added flexi-
bility or security. If desired change the port
number (25 or 1025 ~ 65535).
User Name : Enter the user name.
Password : Enter the password.
Mail Address 1~4 : Enter the mail address.
You can input the E-mail address up to 4.
Note :
The SMTP Server, SMTP Port No., User Name or
Password settings are optional. The DVR can send
e-mail directly without the use of SMTP server or
MTA (message transfer agent). In certain cases all e-
mail should be forwarded to a specific SMTP server.
Specify the server host name or IP address in such
case. For more detail SMTP setup, ask your network
administrator and/or mail service provider.
56
Notification
Set the notification options.
Sensor On : Sending the E-mail when an sen-
sor has been detected.
Motion Detect : Sending the E-mail when an
Motion detection has occurred.
Video Loss : Sending the E-mail when a video
signal from the camera has stopped because
of a cable disconnection or malfunction of a
camera.
Disk Full : Sending the E-mail when the HDD
has fully recorded.
Admin PW Changed : Sending the E-mail
when administrator password has changed.
Power On/Off : Sending the E-mail when
power is On or Off.
Emergency
Notification : Notify to the Emergency Agent about
unit operating information according to your notifi-
cation settings.
IP/Port No. : Enter the IP/Port Number of the
Emergency Agent program is installed in PC.
Factory default port for this function is 9002.
However in some cases it is better to change this
port number for added flexibility or security. If
desired change the port number (1025 ~ 65535).
You can set the IP/Port Number up to 9.