Connecting Atm/Pos; Connecting Network - LG LRD5160 Series Owner's Manual

16 Installation

Connecting ATM/POS

Connect the ATM/POS unit to the ATM/POS port.
ATM/POS device connection
VIDEO
INPUT
LOOP
OUT
VIDEO
INPUT
3
LOOP
OUT
VIDEO
INPUT
LOOP
OUT
VIDEO
INPUT
LOOP
OUT
NOTE
• The following device has been tested and compatibility is
ensured. When you use the multiple ATM/POS device, use the
recommended device.
- AVE Products
› VSI-PRO: Video serial interface
› Regcom: RS-485 networker
› Hydra: RS-485 to RS-232 converter
• The installation and connection work should be done by
qualified service personnel or system installers and should be
conformed to all local codes.

Connecting Network

You can control and monitor the system via network. With
the remote control (monitoring), you can change the system
configuration or monitor the image via network. After the
installation, check the network settings for the remote control and
monitoring work.
Network connection
VIDEO
INPUT
100 - 240 V ~ 50 / 60 Hz
LOOP
OUT
100 - 240 V ~ 50 / 60 Hz
LAN connection
Connect the LAN port to an available 10/100/1000 base-T port with
a straight ethernet cable (not supplied). The NET indicator on the
front panel will be lit.
100 - 240 V ~ 50 / 60 Hz
Automatic network configuration
The DVR can automatically obtain and configure the network
100 - 240 V ~ 50 / 60 Hz
interface via DHCP.
Manually configure network
The DVR may be manually configured by assigning an IP address,
subnet mask, gateway and DNS.
This unit can be supported IPv4 and IPv6 network.
Router
Router
NOTE
100 - 240 V ~ 50 / 60 Hz
Broadband
Broadband
Service
Service