Network Setup - LG LE3116D Owner's Manual

Network setup

TCP/IP Settings
The [DHCP], [IP Address], [Subnet Mask], [Gateway],
[Primary DNS], [Secondary DNS], [TCP/IP Port No.]
and [Web Server Port No.] option settings are not
available in the client program. You can set these
options in the system menu of the DVR.
• Bandwidth Throttle: Enter the bandwidth to
adjust the data traffic.
Mail Settings
Set the mail options.
• Notification: When you mark up the notification
option, notify the user about unit operating infor-
mation by E-mail according to your notification
settings.
• TLS: Mark up when using the TLS (Transport
Layer Security) function.
• SMTP Server: Enter the SMTP Server address.
• SMTP Port No.: Enter the SMTP Port Number.
Typically the TCP port used for SMTP is 25.
However in some cases it is better to change this
port number for added flexibility or security. If
desired change the port number (1 ~ 65535).
• User Name: Enter the user name.
• Password: Enter the password.
• Mail Address 1~3: Enter the mail address.
You can input up to 3 E-mail addresses.
Note:
The [SMTP Server], [SMTP Port No.], [User Name] or
[Password] settings are optional. The DVR can send
e-mail directly without the use of an SMTP server or
an MTA (message transfer agent). In certain cases
all e-mail should be forwarded to a specific SMTP
server. Specify the server host name or IP address
in such cases. For more detail on SMTP setup, ask
your network administrator and/or mail service pro-
vider.
Notification
Set the notification options.
• Sensor On: Sends an E-mail when a sensor has
been detected.
• Video Loss: Sends an E-mail when a video sig-
nal from the camera has stopped because of a
cable disconnection or malfunction of a camera.
• Motion Detection: Sends an E-mail when motion
detection has occurred.
• Power On/Off: Sends an E-mail when power is
on or off.
• Disk Full: Sends an E-mail when the HDD has
fully recorded.
• Admin Password Changed: Sends an E-mail
when the administrator password has changed.
DDNS
• User ID: Enter the DDNS registered user name.
• Password: Enter the user password in [User ID].
Note:
The DDNS function is serviced using a TCP 8245
port by "No-IP"(http://www.no-ip.com/).
In case the DVR is used in the network system with a
firewall, you have to open the TCP 8245 port so that
DDNS data can get into firewall. For more detail on
firewall setup, ask your network administrator and/or
network service provider.
Emergency
• Notification: Notify the emergency agent about
unit operating information according to your
notification settings.
• IP Address, Port: Enter the IP Address and port
number of the emergency agent program installed
in the PC. The factory default port for this func-
tion is 9002. However in some cases it is better
to change this port number for added flexibility or
security. If desired change the port number (1025
~ 65535).
You can set up to 9 IP address and port numbers.
59