Schedule Setup - LG LDV-S504 Owner's Manual

Recording Frame Rate Settings
1. Click the [Frame Rate Settings] button.
The Recording Frame Rate Settings window
appears.
2. Set the each options using the mouse.
- Click : Use to select the option.
- Double-click : Use to change the options value.
Res. : Select the recording resolution.
(NTSC : 352*240, 704*240 or 704*480
PAL : 352*288, 704*288 or 704*576)
Quality : Select the recording picture quality.
(LOWEST, LOW, NORMAL, HIGH or BEST)
Frame Rate : Select the frame rate. The frame
rate is the number of recorded frames in a
second. According to resolution, the frame
rate is set automatically. If you set manually,
refer to as below.
Resolution
352*240
NTSC 704*240
704*480
352*288
PAL 704*288
704*576
Pre : Specify the pre-event recording time that
records the situation until the sensor alarm
signal has input or the motion has detected.
(OFF, 5, 10, 20, 30, 40, 50, 60SEC)
Post : Specify the post-event recording time
that records the situation since the sensor
alarm signal has input or the motion has
detected. (10 ,20, 30, 40, 50SEC or 1, 2, 3, 4,
5, 10MINUTE)
3. Click the [OK] button to confirm the settings.
54
Frame Rate
1, 3, 5, 7.5, 15, 20, 30.
1, 3, 5, 7.5, 15.
1, 3, 5, 7.5.
1, 3, 5, 6, 12.5, 20, 25
1, 3, 5, 6, 12.5
1, 3, 5, 6
Display Settings
1. Set the OSD options for the client live display win-
dows.
If you mark up the [Channel Name] and [Channel
Status] options, it will be displayed on the live
channel windows.
2. Set the Main Monitor option.
3. Set the Spot Monitor options.

Schedule setup

1. Select a day of week.
2. Mark up the desired recording option.
- No recording : Do not schedule recording
- Continuous : Recording starts automatically on
the preset time.
- Sensor : Recording starts automatically when
alarm is occur within a designated time.
- Motion : Recording starts automatically when
motion detected within a designated time.
- Motion+Sensor : Recording starts automatically
when Alarm and Motion detection are occur
within a designated time.
3. Select the channel to set the schedule.
4. Click the start time cell block and drag&drop to
select period time cell block.
or
Click the start time cell block of a channel and
drag&drop across the channels to select the peri-
od time block for multi channels setting at a time.
The cell blocks color will be changed.