Date And Time Actual Values And Commands; Modbus Communications - GE D90 Plus Instruction Manual

MODBUS COMMUNICATIONS

Date and time actual values and commands

Modbus communications
102
Select the Actual Values > Communications > Commands > Set Date and Time menu
item to open the date and time commands window.
Figure 82: Date and time actual values and commands
The following date and time actual values are displayed.
Computer Date
Range: date in MM/DD/YY format
This actual value displays the date specified by the computer running the EnerVista
Plus
UR Setup software.
Computer Time
Range: time in HH:MM:SS format
This actual value displays the time specified by the computer running the EnerVista
Plus
UR Setup software.
Device Date
Range: date in MM/DD/YY format
This actual value displays the date programmed in the D90
Device Time
Range: time in HH:MM:SS format
This actual value displays the time programmed in the D90
The following date and time commands are available.
Sync Relay to Computer
This command sets the D90
computer running the EnerVista UR
Set Manual Date and Time
This command sets the D90
specified by the
Manual Date
The Modicon Modbus protocol is supported by the D90
RS485 serial link (Modbus RTU) or via Ethernet (Modbus/TCP). The D90
slave device, meaning that it never initiates communications; it only listens and responds
Plus
date and time values to the date and time of the
Plus
Setup software.
Plus
date and time values to the date and time values
and entries.
Manual Time
Plus
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: COMMUNICATIONS
Plus
.
Plus
.
. Modbus is available via the
Plus
always acts as a